Skip to main content
How it Works

With the PROFIenergy Profile, the switching mechanisms reside inside the ECUs themselves. These ‘understand’ the PROFIenergy commands issued by the controller.

At times determined during configuration or dynamically decided during production the controller sends ‘start pause’ and ‘end pause’ signals to the ECUs.  Each ECU then decides how this information is handled using software ‘agents’ embedded in its firmware.

Equipment vendors themselves decide how to optimize the energy management of their own equipment in response to these signals.

PROFIenergy allows smart switching of equipment, both off and on, to take account of inter-dependenciesThis provides great flexibility: for example, a drive may be run down to idle over a 30 second period, or perhaps a production cell requires that a conveyor be slowed first before a robot can be put to ‘sleep’ (see right).  If the duration of a pause is long enough perhaps the ECU can be completely disconnected ... but to be ready to re-start its conveyor should be re-started in advance.

PROFIenergy functions are usually deployed in the same controller (e.g. PLC) that is running the automation system but they could reside in a separate energy management controller on the same network. Multi-level ‘sleep modes’ are feasible.



Our well-known PI technologies

PROFIBUS is a standardized, open, digital communications system for all areas of application in manufacturing and process automation.

PROFINET is the innovative open standard for Industrial Ethernet. It satisfies all requirements of automation technology..

IO-LINK is an independent sensor / actuator interface solution for use with PROFIBUS and PROFINET.